为保证骨料仓能连续下料，保证计量精度，除砂石其余材料（土石灰粉煤等）必需用皮带上料机上料，不允许用装载机，汽车或挖掘机等直接上料。严格保证各种原材料的颗粒径及含水量。

To ensure continuous feeding of the aggregate bin and measurement accuracy, materials other than sand and gravel (such as soil, stone, ash, and coal) must be loaded using a belt feeder, and direct loading using loaders, trucks, or excavators is not allowed. Strictly ensure the particle size and moisture content of various raw materials.

有关稳定土拌合机设备的日常保养技巧大家又知道多少呢，下面我们就一起来详细地看一下：

How much do you know about the daily maintenance skills of stabilized soil mixer equipment? Let's take a detailed look together:

每星期打开一次各传动链条罩壳，并在链条上加涂少量的润滑脂，每工作300小时清洗链条一次。

Open each transmission chain cover once a week and apply a small amount of lubricating grease to the chain. Clean the chain every 300 hours of operation.

每班工作结束后，将混合料存仓中的物料排放干净，切断总电源，打开搅拌器的上盖，检查搅拌臂与叶浆的紧固情况，发现螺母松动应立即拧紧，以免叶浆脱落造成事故;清洗或设备中各处所粘附的物料，以免物料粘结硬化，影响设备的正常使用。

After each shift, discharge the materials in the mixed material storage bin thoroughly, cut off the main power supply, open the upper cover of the mixer, check the fastening of the mixing arm and the blade slurry, and tighten the nuts immediately if any looseness is found to prevent accidents caused by the blade slurry falling off; Clean or remove materials adhered to various parts of the equipment to prevent material adhesion and hardening, which may affect the normal use of the equipment.

减速机及电动滚筒按使用说明书中的相应条款执行。

The reducer and electric drum shall be executed according to the corresponding terms in the user manual.

搅拌机缸体上的盖板破损后要及时修复，以免物料飞出伤人。

After the cover plate on the mixer cylinder is damaged, it should be repaired in a timely manner to prevent materials from flying out and injuring people.

搅拌机的传动齿轮每天开机前应涂抹黄油少许。

The transmission gears of the mixer should be coated with a little butter before starting up every day.

每周清洗各皮带机和带式给料机的张紧丝杆一次，并涂上新的润滑脂。

Clean the tensioning screw of each belt conveyor and belt feeder once a week and apply new lubricating grease.

搅拌器的工作条件恶劣，当叶浆磨损到面积不足原来的2/3时，应更换叶浆。

The working conditions of the agitator are harsh. When the blade slurry is worn to less than 2/3 of the original area, the blade slurry should be replaced.

搅拌器集料皮带机上料皮带机各配料机螺旋输送机的轴承处，每天开机前应用黄油枪向油杯中加注润滑脂5-8下，每工作200小时拆开检查，换上新的润滑脂。

At the bearing of the screw conveyor of each batching machine on the mixer, aggregate conveyor, and feeding conveyor, apply grease gun 5-8 times to the oil cup before starting up every day. Disassemble and inspect every 200 hours of operation, and replace with new grease.

本文来自：济南水稳搅拌站更多的内容请点击：我们将会为您提问的问题提供一个满意的服务，欢迎您的来电！

This article is from Jinan Water Stable Mixing Station. For more information, please click: We will provide satisfactory service for the questions you ask. Welcome to call us!