公司新闻
摊铺机工作前和工作时的注意事项
来源：/ 日期：2023-06-14
摊铺机工作前的注意事项：
Precautions before the paver works:
1、发动机转速未达到1600rpm时，各种动作的操作均无效。
1. When the engine speed does not reach 1600rpm, all actions are ineffective.
2、在启动发动机时，必须将行走操纵杆置于中位。
2. When starting the engine, the travel control lever must be placed in the neutral position.
3、柴油机启动后保证电瓶充电指示灯和柴油机机油压力报警灯（绿色）熄灭。
3. After the diesel engine starts, ensure that the battery charging indicator light and the diesel engine oil pressure alarm light (green) turn off.
4、各报警灯发出信号，必须认真查清原因、排除故障，并及时报告、记录，否则机器不能移动。
4. When each alarm light emits a signal, it is necessary to carefully investigate the cause, eliminate the fault, and report and record in a timely manner, otherwise the machine cannot move.
5、在给液压油箱加油时，必须用过滤精度为10μm的过滤机加油！
5. When refueling the hydraulic oil tank, a filtration accuracy of 10 must be used μ M's filter refueling!
6、提升熨平板时，必须将找平油缸提升到中位以上，否则，有损坏机器的可能。
6. When lifting the iron plate, the leveling cylinder must be raised above the center position, otherwise there is a possibility of damaging the machine.
7、螺旋分料装置安装时请将脚踏栅格插入挡板上的孔内，予以覆盖分料杆通道。
7. When installing the spiral dividing device, please insert the foot grid into the hole on the baffle to cover the dividing rod channel.
8、在装卸找平仪的过程当中防止磕碰，轻拿轻放，并注意超声波探头上不要沾上油污等并始终保持探头表面的清洁。
8. During the process of loading and unloading the leveling instrument, prevent collisions, handle it gently, and pay attention not to get oil stains or other substances on the ultrasonic probe, and always keep the surface of the probe clean.
然后济南摊铺机出租厂家再来讲讲摊铺机工作时的注意事项：
Then, the rental manufacturer of Jinan pavers will talk about the precautions for paver operation:
1、摊铺机工作时，无论摊铺的是什么样的材料、什么样的宽度，必须将油门开大位置—即额定转速状态，否则摊铺机工作将不正常。
1. When the paver is working, regardless of the type of material and width being paved, the throttle must be turned to a high position - that is, the rated speed state, otherwise the paver will not work properly.
2、摊铺机在待料的过程当中，发动机怠速的时间不能太长（长不超过5分钟），否则会损坏发动机。
2. During the waiting process of the paver, the idle time of the engine should not be too long (no more than 5 minutes), otherwise it will damage the engine.
3、随时注意检查发动机机油压力和工作温度是否正常。如有不正常情况，则应停机检查排除故障。
3. Check whether the engine oil pressure and operating temperature are normal at any time. If there are abnormal situations, the machine should be shut down for inspection and troubleshooting.
4、注意观察液压油箱温度计，其温度指示不得高于80℃，否则要停机检查原因。
4. Pay attention to observing the temperature gauge of the hydraulic oil tank. The temperature indication should not exceed 80 ℃, otherwise the machine should be shut down to check the cause.
5、注意摊铺机各零部件有无松动或不正常的声响。如有则应停机检查。
5. Pay attention to whether the components of the paver are loose or have abnormal noises. If there is, it should be stopped for inspection.
6、注意摊铺机的发电机或其他电器元件有无过热而烧焦的气味。如有则应停机检查。
6. Pay attention to the generator or other electrical components of the paver for any odor of overheating and burning. If there is, it should be stopped for inspection.
7、注意各系统有无泄漏发生，有则应停机检查排除故障。
7. Pay attention to whether there are any leaks in each system, and if there are, shut down the machine for inspection and troubleshooting.
That's all for the precautions before and during the operation of the paver. I hope you can be helpful. For more information, please visit our website consulting service
公司地址：济南市商河县贾庄镇民营经济创业园
公司名称:2023澳门正版资料免费 
备案号：