公司新闻
装载机发动机启动后及作业时的事项
来源：/ 日期：2023-02-20
①装载机发动机启动后，等制动气压达到气压时再准备起步，以确保行车时的制动性。有紧急制动的把紧急及停车制动阀的按钮按下（只有当气压达到允许起步气压时，按钮才能按下，否则按下去会自动跳起来），使紧急及停车制动释放下，才能挂I挡起步。无紧急制动的只需将停车制动手柄放下，释入停车制动即可起步。
① After the loader engine is started, prepare to start when the brake air pressure reaches the safe air pressure to ensure the brake safety during driving. If there is emergency braking, press the button of the emergency and parking brake valve (only when the air pressure reaches the allowable starting air pressure, the button can be pressed, otherwise it will jump up automatically), so that the emergency and parking brake can be released, and then I gear can be engaged to start. If there is no emergency brake, just put down the parking brake handle and release the parking brake to start.
②装载机在行走道路上的故障物，特别要注意铁块、沟渠之类的障碍物，以免割破轮胎。
② Clear the fault objects on the road of the loader. Pay special attention to the obstacles such as iron blocks and ditches to avoid cutting the tires.
③将后视镜调整好，使驾驶员入座后能有很好的视野效果。
③ Adjust the rearview mirror so that the driver can have a good visual effect after sitting.
④济南装载机租赁厂家提醒，确保装载机的喇叭、后退信号灯，以及所有的保险装置能正常工作。
④ Jinan loader rental manufacturer reminds us to ensure that the horn, back signal light and all safety devices of the loader can work normally.
⑤装载机租赁在即将起步或在检查转向左右灵活到位时，应先按喇叭，以警告周围人员注意。
⑤ When the loader leasing is about to start or when checking the flexibility of turning left and right, the horn should be sounded first to warn the surrounding personnel to pay attention to safety.
⑥在起步行走前，应对所有的操纵手柄、踏板、方向盘先试一次，确定已处于正常状态才能开始进入作业。要特别注意检查转向、制动是否完好。确定转向、制动完全正常，方可起步运行。
⑥ Before starting and walking, all the joysticks, pedals and steering wheels should be tested first, and the operation can only be started after confirming that they are in normal state. Pay special attention to check whether the steering and braking are in good condition. Make sure that the steering and braking are completely normal before starting.
⑦行进时，将铲斗置于离地400mm左右高度。在山区坡道作业或跨越沟渠等障碍时，应减速、小转角，要注意避免倾翻。当装载面在陡坡上开始滑向一边时，必须立即卸载，防止继续滑下
⑦ When traveling, place the bucket at a height of about 400mm from the ground. When working on slopes in mountainous areas or crossing ditches and other obstacles, slow down and turn small corners, and pay attention to avoid tipping. When the loading surface starts to slide to one side on a steep slope, it must be unloaded immediately to prevent it from continuing to slide down
⑧装载机作业时尽量避免轮胎过多、过分打滑；尽量避免两轮悬空，不允许只有两轮着地而继续作业。
⑧ Try to avoid too many tires and excessive skidding during the operation of the loader; Try to avoid two rounds of suspension, and it is not allowed to continue operation with only two rounds of landing.
⑨作牵引车时，只允许与牵引装置挂接，被牵引物与装载机之间不允许站人，且要保持一定的距离，防止出现事故。
⑨ When being used as a tractor, it is only allowed to connect with the traction device. No person is allowed to stand between the towed object and the loader, and a certain safety distance should be kept to prevent safety accidents.
In fact, these operating procedures for loader leasing are small details that ordinary drivers should do. It is easy to meet the requirements. Just pay more attention and pay more attention. Follow us , learn more!
公司地址：济南市商河县贾庄镇民营经济创业园
公司名称:2023澳门正版资料免费 
备案号：