公司新闻
摊铺机出租后使用的操作规程
来源:/ 日期:2022-08-17
如今路面施工的速度在“飞速”的提高,在施工工艺和路面材料及路面结构设计提出了越来越高的要求。那么济南摊铺机出租后使用的操作规程是怎样的呢?
Nowadays, the speed of pavement construction is increasing rapidly, which puts forward higher and higher requirements for construction technology, pavement materials and pavement structure design. What are the operating procedures for the use of Jinan pavers after they are rented?
一、摊铺机操作人员须经过培训,了解机械性能、构造,掌握保养知识,熟练地掌握本机性能及操作要领和事项,并经有关部门确认合格后,方可单独操作。
1、 The paver operators must receive professional training, understand the mechanical performance and structure, master the maintenance knowledge, master the performance, operation essentials and safety matters of the machine, and operate independently after being confirmed as qualified by relevant departments.
二、起动发动机前须检查:油(机油、燃油、工作油、润滑油)量是否足,风扇上皮带松紧度,有无漏油及其部件松动现象。检查当天工作所需的各种配件、附件、工具等是否齐备。
2、 Before starting the engine, check whether the oil (oil, fuel, working oil and lubricating oil) is sufficient, whether the belt on the fan is tight, whether there is oil leakage and whether the parts are loose. Check whether various accessories, accessories and tools required for the work of the day are complete.
三、起动发动机后,怠速运行少两分种后检查各监控系统指示是否正常。
3、 After starting the engine, check whether the indication of each monitoring system is normal after idling for at least two minutes.
四、运料车辆倒料须有人指挥,准确将料卸入机器料斗内。
4、 The unloading of the material transport vehicle must be commanded by someone to accurately discharge the material into the hopper of the machine.
五、摊铺机工作前须和左右调平人员取得联系,确保其他人员不在作业内,方可作业。
5、 Before the paver works, contact the left and right leveling personnel to ensure that other personnel are not in the operation.
六、在作业档向行车走档转换时,须在小油门,机器完全停稳后,各工作部件停止工作情况下进行。
6、 When shifting from the operating gear to the driving gear, it must be carried out when the accelerator is small and the machine is completely stopped and all working parts stop working.
七、操作人员严禁酒后操作,操作设备时须穿戴整齐,不得穿拖鞋,不得有吸烟、饮食等其他有碍作业行为。
7、 Operators are not allowed to operate after drinking. They must wear neat clothes when operating the equipment. They must not wear slippers. They must not smoke, eat or drink and other behaviors that hinder safe operation.
八、摊铺机在工作后,所有防护装置须安装在指定位置上。
8、 After the paver is in operation, all protective devices shall be installed at the designated positions.
九、操作室(台)须保持清洁,及时清理油污等污物,不得乱放工具等其他物品。
9、 The operating room (platform) shall be kept clean, and the dirt such as oil stain shall be cleaned in time. Tools and other items shall not be placed randomly.
十、司机离开操作台前,须将操作机构全部置于“0”位上。
10、 Before leaving the operating platform, the driver must put all the operating mechanisms at the "0" position.
十一、对于液压自动加宽摊铺机加宽时,须注意和观察附近情况,以免伤人和损坏设备。
11、 When the hydraulic automatic widening paver is widened, it is necessary to pay attention to and observe the surrounding conditions to avoid hurting people and damaging equipment.
十二、当摊铺在使用液化气罐加热时,在熄火或失火等情况,须将罐阀关闭。当环境温度高于200C或太阳直晒车气罐时使用气罐加热,气罐须加以遮盖。
12、 When the paving is heated with liquefied gas tank, the tank valve must be closed in case of flameout or fire. When the ambient temperature is higher than 200C or the air tank of the direct sun drying vehicle is used for heating, the air tank must be covered.
十三、摊铺结束后,清洗材料输送、捣实装置、停机时须把熨平板放置在垫木上,机器停放下不得妨碍交通,且应放置警示牌。发动机怠带运行5分钟再熄火,然后切断电源,锁上仪表盘。
13、 After paving, the screed shall be placed on the skid when cleaning the material conveying and tamping devices and stopping the machine. The parking of the machine shall not hinder the traffic, and warning signs shall be placed. The engine shall run idle for 5 minutes and then shut down, then cut off the power supply and lock the instrument panel.
十四、设备保养须按照说明书中的要求进行。
14、 Equipment maintenance shall be carried out according to the requirements in the manual.
十五、设备维修保养时,须:
15、 During equipment maintenance, it is required to:
(一)料斗、熨平板固定牢靠。
(1) The hopper and screed are firmly fixed.
(二)发动机熄火。
(2) The engine stalls.
(三)维修液压系统时,须释放液压系统的余压。
(3) When repairing the hydraulic system, the residual pressure of the hydraulic system must be released.
In addition, the daily maintenance of the equipment should be done well, such as regularly removing the mud, sand and asphalt accumulated on the surface of the paver; Remove the dust and oil dirt on the surfaces of the engine, hydraulic components and other components. Be careful not to get dirt into the fuel filler and air filter. For more information, please visit our website Consult.