公司新闻
压路机定期换液压油方法要正确
来源：/ 日期：2022-05-30
对于压路机来说，液压油是保持机器正常、作业的关键。所以，要想更好的发挥压路机的性能优势，就一定要做好其液压油的定期更换工作，当然操作方法要正确才行。
For the road roller, hydraulic oil is the key to maintain the normal and efficient operation of the machine. Therefore, if you want to give better play to the performance advantages of the roller, you must do a good job in the regular replacement of its hydraulic oil. Of course, the operation method should be correct.
无论是工作时间多长，济南压路机出租厂家都建议液压油每年少更新一次，以防止油液变质污染液压系统。换油之前应先起动发动机运转，将液压油暖热以利于排放。
No matter how long the working hours are, Jinan roller rental manufacturers recommend that the hydraulic oil be updated at least once a year to prevent the oil from deteriorating and polluting the hydraulic system. Before oil change, start the engine to warm up the hydraulic oil for drainage.
应合理控制油的添加量。添加的油越多越好。为防止油加得过多，加注油时应采用少加次数的方法。加注一次后等待约5分钟，观察油尺上的油位，检查油位是否在正常油位，如果不是，继续少加一点，直到油位不低于下刻度线，也不高于上刻度线，刚好在正常油位。
The amount of oil added shall be reasonably controlled. The more oil you add, the better. In order to prevent excessive oil filling, the method of less oil filling times shall be adopted during oil filling. Wait for about 5 minutes after filling once, observe the oil level on the dipstick, and check whether the oil level is at the normal level. If not, continue to add a little less until the oil level is not lower than the lower scale mark, nor higher than the upper scale mark, and just at the normal level.
然后是更换机油。长期使用机油的粘度会逐渐降低，失去润滑作用。如果不更换，会造成发动机零件的磨损。机油含有杂质，长期工作会造成气缸拉缸。因此，要经常检查，定期更换，并根据相应的标签注意机油。滚筒发动机的正常运转和使用寿命与机油息息相关，使用时应注意。
Then change the oil. After long-term use, the viscosity of the engine oil will gradually decrease and the lubricating effect will be lost. If not replaced, engine parts will be worn. The engine oil contains impurities. Long term operation will cause cylinder pulling. Therefore, it is necessary to check frequently, change regularly, and pay attention to the oil according to the corresponding label. The normal operation and service life of the cylinder engine are closely related to the engine oil, which should be paid attention to during use.
更换液压油时，放油时先拧下排放螺塞放空油箱，再拆开系统中进排油路的较低油管接头，排空回路中的油。拆下油箱盖，用柴油清洗油箱内外及箱盖、螺塞、管接头等。清洗完毕，重新装好油塞、管接头及箱盖，加满新油。试车运转，并操纵各液压系统，检查油位及是否渗漏，需要时可再加注适量的油。
When replacing the hydraulic oil, firstly unscrew the drain plug to drain the oil tank, and then disassemble the lower oil pipe joint of the oil inlet and outlet circuit in the system to drain the oil in the circuit. Remove the oil tank cover, and clean the inside and outside of the oil tank, as well as the cover, screw plug, pipe connector, etc. with diesel. After cleaning, reinstall the oil plug, pipe joint and tank cover, and fill with new oil. Test run, operate each hydraulic system, check the oil level and whether there is leakage, and refill an appropriate amount of oil when necessary.
压路机运行前应做好准备工作，以减少设备运行过程中出现故障的概率，液体检查，量应充足，不应有渗漏。此外，还需要检查小辊相互连接的部分是否有松动现象。压路机作业前，先检查周边施工环境，并提前清理周围有障碍物的环境，方可正式作业压路机作业。而且，操作人员要精通压路机的操作方法，正确操作。调整小滚筒，使其处于良好的工作状态。
Preparations shall be made before the operation of the roller to reduce the probability of failure during the operation of the equipment. The liquid inspection shall be sufficient without leakage. In addition, it is also necessary to check whether the connecting parts of the small rollers are loose. Before the operation of the roller, the surrounding construction environment shall be checked first, and the surrounding environment with obstacles shall be cleared in advance before the formal operation of the roller. Moreover, the operator shall be proficient in the operation method of the roller and operate correctly. Adjust the small roller to make it in good working condition.
Therefore, it is not only necessary to add the hydraulic oil in time, but also to replace it regularly. Therefore, it is also important to add the hydraulic oil of the road roller. The above is the relevant content. You can pay attention to our website www.ycgjglcl Learn about. Com for more information.
公司地址：济南市商河县贾庄镇民营经济创业园
公司名称:2023澳门正版资料免费 
备案号：