公司新闻
济南装载机的作业操作规定
来源：/ 日期：2022-05-16
作业环境
Working environment
1、装载机不得在倾斜度超过规定的场地作业，作业区域内不得有障碍物和无关人员。
1. The loader shall not operate on the site with an inclination exceeding the specified, and there shall be no obstacles and irrelevant personnel in the operation area.
2、装载机的运输距离不宜过大，行驶道路要平坦。在石材工地作业时，装载机应在轮胎上安装保护链或使用带直边轮胎的钢链板。
2. The transportation distance of the loader should not be too large, and the driving road should be flat. When working on the site, the tire protection belt shall be installed on the steel belt of the stone loader.
3、运行前的检查和启动
3. Inspection and startup before operation
4、作业前应检查液压系统无泄漏，液压油箱油量充足，轮胎气压符合规定，制动灵敏可靠。
4. Before operation, check that the hydraulic system has no leakage, the hydraulic oil tank has sufficient oil, the tire pressure meets the regulations, and the braking is sensitive and reliable.
作业中的注意事项
Safety precautions during operation
1、启动前应发出声音，将铲斗抬离地面约0.5m。作业时应使用低速档，高速行驶时不要提升和转动铲斗。桶内严禁载人。
1. Before starting, make a sound and lift the bucket about 0.5m off the ground. The low gear shall be used during operation, and the bucket shall not be lifted and rotated when driving at high speed. It is forbidden to carry people in the barrel.
2、装积沙时，应低速插入铲斗，逐渐提高内燃机转速向前移动。
2. When loading sand, insert the bucket at low speed, gradually increase the speed of the internal combustion engine and move forward.
3、在松散不平的场地作业时，可将铲臂置于浮动位置，使铲斗平衡向前推进。
3. When working on loose and uneven ground, the shovel arm can be placed in the floating position to make the bucket move forward in balance.
4、装载时，铲斗应从前面插入，以防止铲斗一侧受力。
4. When loading, the bucket should be inserted from the front to prevent stress on one side of the bucket.
5、卸到运输车上时，要慢，向前和返回时铲斗不能与车箱相撞。
5. When unloading onto the transport vehicle, it shall be slow. The bucket shall not collide with the vehicle body when moving forward and returning.
6、铲臂上下移动到时，应迅速将操纵杆回位中位，防止在阀作用下产生噪音和误动作。
6. When the shovel arm moves up and down to the maximum, quickly return the control lever to the middle position to prevent noise and misoperation under the action of the safety valve.
7、时刻注意各种仪表和指示信号的作业情况，听听内燃机等部位的运转声。如发现异常，应立即停车检查。只有在故障排除后才能继续作业。
7. Always pay attention to the operation of various instruments and indication signals, and listen to the running sound of internal combustion engine and other parts. In case of any abnormality, stop the machine immediately for inspection. Work can only be continued after troubleshooting.
8、装载机臂架升起后进行润滑和调整时，必须安装销或采取其他措施，防止臂架坠落伤人。
8. When lubricating and adjusting the loader boom after lifting, safety pins must be installed or other measures must be taken to prevent the boom from falling and hurting people.
9、装载机工作过程中，应注意随时轮胎（或履带）间夹杂的碎石。
9. During the working process of the loader, pay attention to remove the gravel mixed between the tires (or tracks) at any time.
10、装载机及工作场所夜间工作时应有良好的照明。
10. Loaders and workplaces shall have good lighting when working at night.
11、刹车、喇叭、转向机应齐全、灵敏，行车时必须遵守：“交通规则”。 如果需要经常上路行驶，司机必须持有“机动车驾驶证”。
11. The brake, horn and steering gear shall be complete and sensitive, and the "traffic rules" must be observed when driving. If it is necessary to drive on the road frequently, the driver must hold a "motor vehicle driver's license".
作业后注意事项
Safety precautions after operation
济南装载机租赁厂家在此提醒您，在装载机的作业结束后，铲斗应平放在地面上，操纵杆置于空档位置，并拉紧手动刹车。更多相关信息的了解就来网站看看吧。
Jinan loader rental manufacturer reminds you that after the operation of the loader, the bucket should be placed flat on the ground, the control lever should be placed in the neutral position, and the manual brake should be tightened. For more information, please visit Check it out. Www. 68mn.
公司地址：济南市商河县贾庄镇民营经济创业园
公司名称:2023澳门正版资料免费 
备案号：